The T105mm Tapered MAXEdge is designed to "taper" earlier than our traditional 15 or 20mm tapered edge to allow a straight hold down fixing.
Testing Completed with BRANZ October 2023
- Can be used in conjunction with MAXSlab, MAXRaft, MAX85 and MAXRaft Plus where 90mm frame is specified.
- Bolt specification must be either Hilti 10x150 HUS4-H Anchors or M10x140 Bowmac Bluehead Anchors as tested at 900mm centres.
- The same anchors will provide a 15 kN fixing for end studs of bracing wall elements.
Taper 105mm Detail (T105)
Testing Completed with BRANZ January 2020
- Can be used in conjunction with MAXSlab, MAXRaft, MAX85 and MAXRaft Plus where 90mm frame is specified.
- Bolt specification must be Simpson Strong-Tie TITEN HD THD10160MG screw anchors at 600mm centres or Simpson Strong-Tie AT-HP BLUE anchoring adhesive with M12 5.8 grade stud, 100mm embedment at 600mm crs as Tested.
- The same anchor will provide a 15 kN fixing for end studs of bracing wall elements.
Angled fixing applies to Taper 15mm or 20mm Detail with 90mm framing
See more about R-values by visiting our Performance page or Contact us.
BRANZ testing found here